Commscope BOSTM BrightPath Optical Solutions Manual de usuario descargar pdf (Pagina 42)

Attach the cable to the residence

Using a ladder or a lift truck, climb up to the attachment point and screw or drive a P-hook or Q-hook into the resi-

dence. A good attachment point is the corner of the house under the soffit. NEVER attach to an antenna, rain gutter,

chimney, power mast or lightning rod. The hook should be parallel to the ground.

The attachment point should not be any closer than 4 in. (10 cm) from a telephone cable or 1 foot (30 cm) from a

power line. Make certain you meet all clearance requirements.

Taking the cable in hand, climb up to the attachment point. Pull the cable

taut until the sag is 1% of the overall length of the drop (examples: for a

100’ run, the sag should be 1 foot; for a 50 foot run, the sag should be

1/2 foot). Use your hand to mark the place on the cable where the cable

and the hook meet while maintaining proper sag. DO NOT pull the cable

through the hook or attach it to the hook.

Attach the drop wire clamp

Select a point on the cable where the drop wire clamp’s wedge would meet the cable if the clamp were attached

to the hook. Use the technique described on page 9.8 to trap the cable in the clamp’s shell with the shim. Slide the

wedge into the clamp. The cable sag can be adjusted by freeing the wedge and moving the shell and shim along

the cable.

9.9 Drop and NID/NIU installation

Attaching the cable to the residence

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48

Sin comentarios

Modelle	Dokumententyp
QUICKPRO TS-30	Bedienungsanleitung Haan QUICKPRO TS-30 User Manual, 20 Seiten
STEAM STATION GS-60	Bedienungsanleitung Haan STEAM STATION GS-60 User Manual, 26 Seiten

Commscope BOSTM BrightPath Optical Solutions Manual de usuario Pagina 42